Per configurare Wi-Fi Protected Access (WPA) dalla command-line segui questi step:

1. Entra in enable mode

2. Inserisci il comando configure terminal. Usa questa configurazione:

AP(config-ssid)#wpa-psk ascii testtest

AP(config-ssid)#authentication key-management wpa

AP(config-ssid)#exit



AP(config)#interface dot11radio 0

AP(config-if)#encryption vlan 3 mode ciphers tkip

AP(config-if)#ssid test

AP(config-if)#exit



AP(config)#interface dot11 0.3

AP(config-subif)#encapsulation dot1q 3

AP(config-subif)#bridge-group 3

AP(config-subif)#exit



AP(config)#interface fastethernet 0.3

AP(config-subif)#encapsulation dot1q 3

AP(config-subif)#bridge-group 3

AP(config-subif)#exit